Nickel Alloy
200/201

Printable Version (PDF)

 
Specifications (ASTM/ASME)
Alloy UNS Designation Material
Specification
Tubing
Specification
Pipe
Specification
200/2011 N02200/N022011 B 162/SB-162 B 7302 B 725

1 Supplied as dual certified material.

2 ASTM has withdrawn this specification, with no replacement (used for reference purposes only).

Chemical Composition (%)
Alloy 200 201
UNS Designation N02200 N02201
Carbon (C) max. 0.15 0.02
Manganese (Mn) max. 0.35 0.35
Sulfur (S) max. 0.01 0.01
Silicon (Si) max. 0.35 0.35
Nickel (Ni) plus Cobalt (Co) min. 99.0 99.0
Copper (Cu) max. 0.25 0.25
Iron (Fe) max. 0.40 0.40
Typical Physical & Mechanical Properties - Annealed Condition (Room Temperature)
Alloy UNS Designation Minimum Tensile Strength
Minimum Yield
Strength
0.2% Offset
Minimum Percent (%)
Elongation in
2 inches (50.8 mm)
(psi) (MPa) (psi) (MPa)
200 N02200 --- --- --- --- ---
201 N022011 50,000 345 12,000 80 35
201 N022012 50,000 345 10,000 70 40

1 Outside diameter 5" (127 mm) and under.

2 Outside diameter over 5" (127 mm).

 

Disclaimer: Johnson Tube Company™, a division of Johnson International Industries, Inc., has gathered the information contained in this website from many different sources. To the best of our knowledge, all information is correct and accurate at the time of publication, but is intended to supply general information only. The information presented here is given as a guide, for reference purposes only and should not be used as technical/design specifications. The reader must make their own evaluation, based on their own research and more specific information than that supplied here, by Johnson Tube Company™, all information must be verified by the reader. Johnson Tube Company™, a division of Johnson International Industries, Inc., are processors and re-sellers of these materials and makes no guarantees or warranties, either expressed or implied, regarding the accuracy of the information supplied or the suitability of any material for any application. Information and specifications are subject to change without notice.

Not all products are produced by Johnson Tube Company™, a division of Johnson International Industries, Inc., but all products meet or exceed stated specifications.