Stainless Steel
Austenitic 347/347H

Printable Version (PDF)

 
Specifications (ASTM/ASME)
Alloy UNS Designation Material
Specification
Tubing
Specification
Pipe
Specification
347 S34700 A 240/SA-240 A 249/SA-249 A 312/SA-312
      A 269 A 778
      A 554 ---
347H S34709 A 240/SA-240 A 249/SA-249 A 312/SA-312
Chemical Composition (%)
Alloy 347 347H
UNS Designation S34700 S34709
Carbon (C)  0.08 max. 0.04 - 0.10
Manganese (Mn) max. 2.00 2.00
Phosphorus (P) max. 0.045 0.045
Sulfur (S) max. 0.030 0.030
Silicon (Si) max. 0.75 0.75
Chromium (Cr) 17.0 - 19.0 17.0 - 19.0
Nickel (Ni) 9.0 - 13.0 9.0 - 13.0
Columbium (Cb) 10 x C min., 1.00 max. 8 x C min., 1.00 max.
Iron (Fe) Balance Balance
Typical Physical & Mechanical Properties - Annealed Condition (Room Temperature)
Alloy UNS Designation Minimum Tensile Strength
Minimum Yield
Strength
0.2% Offset
Minimum Percent (%)
Elongation in
2 inches (50.8 mm)
(psi) (MPa) (psi) (MPa)
347 S34700 75,000 515 30,000 205 35
347H S34709 75,000 515 30,000 205 35

 

Disclaimer: Johnson Tube Company™, a division of Johnson International Industries, Inc., has gathered the information contained in this website from many different sources. To the best of our knowledge, all information is correct and accurate at the time of publication, but is intended to supply general information only. The information presented here is given as a guide, for reference purposes only and should not be used as technical/design specifications. The reader must make their own evaluation, based on their own research and more specific information than that supplied here, by Johnson Tube Company™, all information must be verified by the reader. Johnson Tube Company™, a division of Johnson International Industries, Inc., are processors and re-sellers of these materials and makes no guarantees or warranties, either expressed or implied, regarding the accuracy of the information supplied or the suitability of any material for any application. Information and specifications are subject to change without notice.

Not all products are produced by Johnson Tube Company™, a division of Johnson International Industries, Inc., but all products meet or exceed stated specifications.